Configuring Non-Registered Device Settings - Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2 - ADMINISTRATION GUIDE 02-12-2010 Administration Manual

29.4.3 Configuring Non-registered Device Settings

The following configurations can be set after a device is imaged. The settings are applied to devices
not registered in the ZENworks Management Zone.
For more information, see
To configure default ID settings for non-registered devices:
1 In the ZENworks Control Center, click the Configuration tab, which displays the following
Management Zone Settings section:
2 In this section, click Preboot Services to display the configuration sections.
3 Locate the Non-Registered Device Settings section:
4 Fill in the fields:
Section 28.3.4, "Non-registered Device Settings," on page 334.
Setting Up Preboot Services 383