Table of Contents
Advertisement
36.4.1 Starting Remote Management Operations Using the
Windows VNC Viewer
1 Download the latest stable version of the native VNC Viewer from the
(http://www.tightvnc.com/download.html).
2 Install Tight VNC from the executable you have downloaded.
3 Launch the Tight VNC Viewer from Start > Programs > Tight VNC > Tight VNC Viewer.
IMPORTANT: We recommend using Tight VNC Viewer (Fast Compression) over fast links
and Tight VNC Viewer (Best Compression) over slow links.
4 In Connection details, specify the IP address with a port number as configured, then click OK.
You can specify the port number after the IP address with a double colon (::) preceding it. For
example, if the IP address of the managed device is 192.168.0.1, and the Remote Control
Service port number is 5950, specify as 192.168.0.1::5950.
You can specify the display number after the IP address with a single colon (:) preceding it. For
example, if the IP address of the managed device is 192.168.0.1, and the Remote Control
Service port number is 5950, specify the IP address as 192.168.0.1:50.
You can also specify a DNS name instead of an IP address.
5 In VNC authentication, specify the correct password, then click OK.
Now, you will have an access to the desktop of the managed device you have specified.
36.4.2 Starting Remote Management Operations Using the
Linux VNC Viewer
1 Download the latest stable version of native VNC Viewer from the TightVNC Web site at
TightVNC web site
2 Install Tight VNC from the RPM Package you have downloaded.
3 Launch Tight VNC Viewer by specifying the following command at the Shell prompt:
$ vncviewer
4 In serverDialog, specify the IP address with a port number as configured, then click OK.
494 Novell ZENworks 7.2 Linux Management Administration Guide
(http://www.tightvnc.com/download.html).
TightVNC web site
Advertisement
Table of Contents
Troubleshooting
