Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual page 65

no-verified-certs.Specify the IP addresses of the servers (separated by a comma) for which
you do not want to verify the SSL certificates. The servers are excluded only if require-
verified-certs is True.
proxy-password. Password for the proxy, if any.
proxy-url.URL for the proxy server.
NOTE: If you modify the system proxy, you must set the proxy-url with the system proxy
URL for the device to use the system proxy. You can set the proxy URL either by using
the rug command or through the zmd settings in the ZENworks Control Center. For more
information on how to use the rug command, see rug (1). For more information on how to
configure the zmd settings, see Section 7.10, "Configuring the ZENworks Management
Daemon (zmd) Settings," on page 74.
proxy-username. Username for the proxy, if any.
proxy-excludes. Specify the IP address or the DNS name of the server that you want to
exclude from using the proxy settings. You can specify multiple IP addresses or DNS
names by separating the same with a comma. You can use the * wildcard character only in
the IP address. Ensure that there is no space in the specified IP address or the DNS name.
refresh-interval. How long between refreshes, in seconds. The default is 7200 seconds.
refresh-interval-hardware. How long between hardware refreshes. The default is 86400
seconds.
refresh-interval-software. How long between software refreshes. The default is 86400
seconds.
refresh-interval-system. How long before system refreshes. The default is 86400 seconds.
remote-enabled. Allow clients to connect to this daemon remotely. The default is True.
remote-port. Port used for connections of remote clients. The default value is 5505.
require-verified-certs. Verify SSL certificates from server. This should remain False
unless your ZENworks Linux Management server has a signed SSL certificate (generated
or purchased). The default is False.
retry-delay. The number of milliseconds to delay before retrying a download. The default
is 2000 milliseconds.
rollback. Store more detailed transaction history, enabling rollback feature. The default is
False.
run-transaction-test. Run a dryrun before attempting to install or remove packages. The
default is True.
security-level. Security requirements to enforce. Possible values are signature, checksum,
and none. The default is Checksum.
service-retry-interval. The default is 300 seconds.
sleep-interval. The number of seconds before the next Service Refresh schedule wakes up.
The default is 300 seconds.
sleep-threshold. The default is 600 seconds.
software-inventory-enabled. If True, software inventory information will be collected and
sent to the server. The default is True.
syslog-level. Sets the log level. Options are off, fatal, error, warn, info, and debug. The
default is Info.
ZENworks Agent 65