Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual page 410

This add-on image can be used in
Bundle for Automatic Imaging" on page
Manually Putting an Image on a Device
The section explains how to put an image on the device by booting from an imaging method and
entering a particular imaging command. The image is retrieved from your imaging server.
Ensure that the device receiving a new image has enough disk space for the image. Otherwise, you
receive a "Failed to write to proxy" error.
The following sections contain additional information:
"Manually Putting an Image on a Device Using the Bash Prompt" on page 410
"Manually Putting an Image on a Device Using the ZENworks Imaging Engine Menu" on
page 411
Manually Putting an Image on a Device Using the Bash Prompt
1 If you haven't already done so, create the image to put on the device, as instructed in
"Manually Taking an Image of a Device" on page
Make sure that the image is of the same type of device (same hardware configuration) and is
stored on your imaging server. You can use a previous image of the same device.
IMPORTANT: If you are putting an image on a device without a ZENworks partition, make
sure the image was made on a device without a ZENworks partition. Otherwise, the wrong
MBR (Master Boot Record) is restored, and the device fails to boot.
2 (Optional) Boot the device from a Windows startup disk and run fdisk to remove all
partitions from the hard disk.
Running fdisk is not required, but it is recommended for purposes of comparing workstation
or server partitions before and after the imaging operation.
3 Boot the device using one of the following methods:
If the device is PXE-enabled, boot it from the Preboot Services imaging server. For more
information, see
Boot the device using an imaging boot CD or DVD. For more information, see
Section 29.2.2, "Preparing Imaging Boot CDs or DVDs," on page
Boot the device from the ZENworks partition. For more information, see
ZENworks Partition" on page
4 Enter manual at the bash prompt.
This step is not the same as in the previous step's manual processes.
5 (Optional) At the bash prompt, type img dump, then press Enter to display a list of the
partition slots on the device.
For your reference, note the number and type of partitions and which one is active. If you
removed all partitions using fdisk, each slot should be empty and none should be active.
6 Enter a command at the bash prompt using one of the following formats:
To restore an image from the imaging server and put it down on a device, enter:
img restorep serverIPaddr_or_DNSname //uncpath/newimg.zmg
410 Novell ZENworks 7.2 Linux Management Administration Guide
Step 8 on page 402
400.
Section 29.2.1, "Using Preboot Services (PXE)," on page
354.
under "Configuring the ZENworks Image
405.
346.
346.
"Creating a