Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual page 343

DRAC Configuration File: You can run a supplied script to create your DRAC 4 or earlier
configuration file.
Dell Utility Partition: You can create a Dell utility partition when imaging the device,
including setting its size, specifying the target disk, indicate whether to use a specific Dell
utility partition file, and indicate whether to overwrite any existing utility files.
Preboot Bundle: You can immediately perform an operating system installation after
configuring the Dell device by specifying the Preboot bundle containing that installation
configuration.
The above options are only for configuring, not for updating these settings. These configurations are
applied to the Dell device when it boots and uses the Dell Configuration Preboot bundle that it is
assigned to.
To properly configure Dell devices, you can also do the following:
Keep your Dell DTK upgraded to the latest version (see
DTK," on page 649).
Create Dell configuration scripts and files to be used in the Dell Configuration Preboot bundle
(see Section 30.5.1, "Creating Dell Configuration Scripts and Files," on page
Create a Dell Configuration Preboot bundle (see
Bundles," on page 447).
Troubleshoot Dell Configuration Preboot bundles (see
Linux Management Troubleshooting
Appendix G, "Upgrading the Dell
Section 30.5.2, "Creating Dell Configuration
"Dell
Guide).
Understanding Preboot Services in ZENworks Linux Management 343
444).
DTK" in the Novell ZENworks 7.2