Section F.7.2, "Linuxrc Parameters Specified in Settings.txt," on page 646
Section F.7.3, "Image Engine Variables," on page 647
F.7.1 Imaging Script Variables
The following environment variables are used in imaging scripts and must not be modified:
Imaging Script Variables
Table F-1
Variable
ACTIVEPARTITION Device of the active OS partition.
CDBOOT
DISABLEZEN
ENABLEZEN
ZENDEVICE
ZENPARTBOOT
The following environment variables can be modified or set in the settings.txt file:
Environment Variables
Table F-2
Variable
HDPARM
IMGCMD
MANUALREBOOT
PARTITIONSIZE
PROXYADDR
PROMPT
F.7.2 Linuxrc Parameters Specified in Settings.txt
Linuxrc Parameters
Table F-3
Variable
netsetup
HostIP
NetMask
646 Novell ZENworks 7.2 Linux Management Administration Guide
Definition
YES = Booted from a CD.
1 = Disable the ZENworks partition.
1 = Re-enable the ZENworks partition.
Device name of the ZENworks partition.
YES = Booted from ZENworks partition.
Definition
NO = Do not set hdparm parameters.
Imaging command to run instead of the img a command.
YES = Do not automatically reboot.
Size in MB to create the ZENworks partition.
IP/DNS address of the Imaging server.
Go to the bash prompt after imaging is complete.
Definition
dhcp = Use DHCP.
1 = Static IP.
Static IP address to use.
Network mask.