Starting Image Explorer (Imgexp.exe); Opening An Image; Adding A File Or Folder To An Open Image - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual

Section D.1.2, "Opening an Image," on page 592
Section D.1.3, "Adding a File or Folder to an Open Image," on page 592
Section D.1.4, "Creating a Folder in an Open Image," on page 593
Section D.1.5, "Excluding a File or Folder from a File Set in the Open Image," on page 593
Section D.1.6, "Marking a File or Folder for Deletion in the Open Image," on page 593
Section D.1.7, "Purging Files and Folders Marked for Deletion from the Open Image," on
page 593
Section D.1.8, "Extracting a File or Directory from the Open Image to a Folder," on page 593
Section D.1.9, "Extracting a File or Directory from the Open Image As an Add-On Image," on
page 593
Section D.1.10, "Viewing a File from the Open Image in its Associated Application," on
page 594
Section D.1.11, "Saving Your Changes to the Open Image," on page 594
Section D.1.12, "Creating an Add-On Image," on page 594
Section D.1.13, "Adding a Partition to a New Add-On Image," on page 594
Section D.1.14, "Compressing an Image," on page 594
Section D.1.15, "Splitting an Image," on page 595
Section D.1.16, "Resizing a Partition in an Image," on page 596
D.1.1 Starting Image Explorer (imgexp.exe)
The Image Explorer utility must be run on a Windows device. You need Samba running on the
Linux imaging server where the utility file is located in order for the Windows device to have access
to it.
There are no command line parameters for the Image Explorer utility.
1 To start Image Explorer, run the following file:
/opt/novell/zenworks/zdm/imaging/winutils/imgexp.exe
D.1.2 Opening an Image
1 Start Image Explorer.
2 Click
Large image files might take a few moments to open.
D.1.3 Adding a File or Folder to an Open Image
1 Start Image Explorer.
2 In the left pane, browse to the partition or directory where you want to add the file or folder.
3 Click
592 Novell ZENworks 7.2 Linux Management Administration Guide
on the toolbar, browse for and select the image (.zmg) file, then click Open.
or on the toolbar, browse to the file or folder, then click Add or OK.