Adding Bundles To Catalogs; Renaming Or Moving Catalogs - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual

22.4 Adding Bundles to Catalogs

You can use the ZENworks Control Center or the zlman command line utility to add bundles to
catalogs. The following procedure explains how to perform this task using the ZENworks Control
Center. If you prefer the zlman command line utility, see the Catalog Commands section of
(1) (page 547).
1 In the ZENworks Control Center, click the Bundles tab.
2 In the Bundles list, select the box next to the bundle's name, click Action, then click Add to
Catalog to display the Targets page.
3 Select the catalog to contain the selected bundles.
3a Click Add to open the Select Catalogs dialog box, then click the desired catalogs to add
them to the Selected list.
3b Click OK to display the selected catalogs in the list on the Targets page.
4 Click Next to display the Finish page, review the information on the Finish page, make any
changes to the settings by using the Back button as necessary, then click Finish to add the
bundle to the catalog.

22.5 Renaming or Moving Catalogs

You can use the ZENworks Control Center or the zlman command line utility to rename or move
catalogs. The following procedure explains how to perform this task using the ZENworks Control
Center. If you prefer the zlman command line utility, see the Catalog Commands section of
(1) (page 547).
Use the Edit drop-down list on the Bundles page to edit an existing object. To access the Edit drop-
down list, you must select an object by clicking the check box next to the object's name in the list.
274 Novell ZENworks 7.2 Linux Management Administration Guide
zlman
zlman