Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual page 488

3 To enable the Remote Control Service on a particular port, select the Enable remote control
service on port option.
By default, the Remote Control Service listens on port number 5950.
4 Select Allow full control or Allow view only.
Select Allow full control to enable the user to perform both remote control and remote view
operation to a managed device. Select Allow view only to enable the user to perform only
remote view operations to a managed device. Selecting Allow view only disallows the user to
perform remote control operation.
5 Select the Ask for permission from user on the managed device option to request the permission
of a user on the managed device before starting a Remote Control or Remote View session.
6 To enable Remote Login Service on a particular port, select the Enable remote login service on
port option.
By default, the Remote Login Service listens on port 5951.
7 In the Password Policy for Remote Management Sessions section, select the desired option.
Select Use same password across sessions to use the same password across all sessions. By
default, this option is selected. Select Clear the password after every session to set the
password for every session. If you select this option, the password is cleared after every
successful or unsuccessful attempt for a Remote Management operation. If you want to launch
a Remote Control, Remote Login, or Remote View operation without asking for a password,
select No password.
NOTE: We recommend you to use the No password option judiciously as it allows access to
the managed device without any password.
8 Click Apply.
These changes will be effective on the managed devices on their next Settings Refresh Schedule.
488 Novell ZENworks 7.2 Linux Management Administration Guide