Changing The Debug Settings Of Zenworks Control Center - Novell ZENWORKS LINUX MANAGEMENT 7.2 IR2 - ADMINISTRATION GUIDE 09-25-2008 Administration Manual

3.5 Changing the Debug Settings of ZENworks
Control Center
To change the debug settings of ZENworks Control Center:
1 Open the /var/opt/novell/zenworks/www/tomcat/base/webapps/
zenworks/WEB-INF/config.xml file in a text editor.
2 Make sure that the value of debug.enabled is set to True. (By default, the option is set to
True.)
The error messages logged by using WebLogger.debug() are written to the standard output.
3 (Optional) Set the value of debug.tags is set to any of the following values:
rpcToServer
controlTree
snapshotTimes
pageLoadTime
requestParams
viewStateManager
RemoteManagement
WebFramework
mirrorStatus
The error messages logged to WebLogger.debugForTag() are written to the standard output.
4 Save the config.xml file.
5 Restart the service by executing the following command:
/etc/init.d/novell-zenserver restart
ZENworks Control Center 43