Lpd/Lpr Setup - Kyocera KM-8530 User Manual

Chapter 21 Printing by LPD/LPR from Windows NT 4.0/2000/XP

LPD/LPR Setup

The network interface card is equipped with the standard print server protocol (LPD: Line Printer Daemon) for
TCP/IP, which enables you to use network printing service for TCP/IP (LPR: Line Printer Remote) from Win-
dows NT 4.0 (Service Pack 3 or later) or Windows 2000/XP computers to print.
To use the TCP/IP network protocol for LPD/LPR printing, the network interface card must be set up for TCP/IP
in advance.
●
Adding a printer port on Windows NT 4.0
To print by LPD/LPR from Windows NT computer, add a printer port and install the printer driver on Windows
NT.
Before doing
Confirm the following settings:
Important
Confirm that TCP/IP is set up correctly on the Windows NT/2000/XP computer using the main
body printer via the network interface card before setting up the print controller.
For TCP/IP setting refer to Windows NT/2000/XP on-line help, etc.
• TCP/IP setting to each Windows NT computer
• Installation of [Microsoft TCP/IP Printing]
Important
Installation of [Microsoft TCP/IP Printing]
Select [Network] from the [Control Panel] of Windows NT 4.0 to display the [Network] dialog
box. Click the [Service] tab and make sure that [Microsoft TCP/IP Printing] exists in the list of
[Network Services]. If it is not found, add it.
For details, refer to Windows NT on-line help, etc.
To add a various services to Windows NT, the CD-ROM for setting up Windows is required.
Chapter 21 Printing by LPD/LPR from Windows NT
557
Chapter
21
4.0/2000/XP