Chapter 25 Apple Talk Configuration; Preparation To Print From Macintosh - Kyocera KM-8530 User Manual

Chapter 25 Apple Talk Configuration

Preparation to print from Macintosh

●
Configuration for Apple Talk
The AppleTalk protocol must be enabled before printing can be performed.
Use the Control Panel, MAP utility or Web Utilities for Windows to check or to enable the AppleTalk protocol.
• Print to the printing system by using Chooser to select the network and printer.
• The network interface card is found in Chooser as IB1_(serial number) 1, where 1 stands for the print con-
troller.
●
How To Access The HTTP Server With A Web Browser
Access to the HTTP Server allows you to perform all network interface card functions.
Use the following procedure to access HTTP (HyperText Transfer Protocol) with the standard Web Browser,
such as Netscape or Internet Explorer (4.x or higher).
1.
2.
Important
Macintosh OS X is not supported.
(p.533) AppleTalk Setup
Reference
(p.533) Printer Name
Reference
(p.533) Zone Name
Reference
Assign an IP address to the network interface card.
(p.527) IP Address
Reference
Start the Web Browser you normally use.
When the Browser is up and running, type http:// followed by the IP address of the unit in the Location
field at the top of the Browser screen, or by going to [File] at the menu bar and choosing Open Loca-
tion. Example: For a unit with an IP address of 199.9.200.200, type:
http://199.9.200.200
If you designate the proxy setting in your Web Browser you cannot access the Web Utilities.
For more information on the proxy settings. See your network administrator.
For more information on the Web Utilities, refer to the ''Web Utilities User's Reference Guide.''
Chapter 25 Apple Talk Configuration
581
Chapter
25