Admin Password - Kyocera KM-8530 User Manual

Setups on the Control Panel (Continued)
●
DNS Setup
Lets you set up DNS (Domain Name Service) settings for the network your copier is connected to.
DNS Server
Lets you enter the address of a DNS server.
• This is made up of four sets of numbers (each from 0 to 255), separated by dots.
NIC Domain Name
Lets you enter the domain name of a network interface card.
• A maximum of 127 bytes of symbols and alphanumeric characters is available.
●

Admin Password

Lets you enter a password between 4 and 8 bytes or change the current password.
You can use numbers, as well as alphabetical letters.
The default is [sysadm].
To change the password, enter it in [Current Password], enter a new password in [New Password], and
again enter the new password in [Confirmation]. Press the [OK] button to validate the change.
If you have forgotten the renewed password, you can enter [3069] in [Current Password], enter a new password in
[New Password] and [Confirmation].
538
Chapter 19 Copier Setup