Kyocera KM-8530 User Manual page 196

To output offset copies (Continued)
●
Operating procedures of
Limitation
[Offset] cannot be set in the following cases:
• When [Finisher] is not available in [Device Options] tab
• When [Sub tray] is selected in [Paper] tab - [Output bin]
• When [Fold only], [Fold, Trim], [Fold, Stitch] or [Fold, Stitch, Trim] is selected in [Device
Options] tab
If you attempt to make a setting corresponding to the incongruous combinations described that cannot be set on
the printer driver, a message will be displayed. Check the details of the message and adjust the relationship with
other settings.
1.
Open [Device Options] tab of the [Properties] window.
When displayed from an application with Windows 98.
•
For Windows NT4.0, [Document Defaults...] - [Advanced] tab is displayed
•
For Windows 2000/XP, [Properties] - [Advanced] - [printing Defaults] - [Layout] - [Advanced...] is displayed
2.
Select [Job Offset] from the [Printer features] field.
3.
Click the [▼] button beside the [Printer features] - [Change setting for]
boxes to display the list. Then select [On] from the list.
The default is [Off].
4.
Click the [OK] button to close the [Properties] window.
Adobe PS3
196
Chapter 5 Printing from Windows