Kyocera KM-8530 User Manual page 237

To set stapling (Continued)
●
Operating procedures of
Limitation
[Stapling] cannot be set in the following cases:
• When [Finisher] is not available in [Device Options] tab
• When [A6] or [B6] is selected in [Paper size]
• When [OHP] is selected in [Paper type]
• When [Sub Tray] is selected in [Paper] tab - [Output bin]
• When [Fold only], [Fold, Trim], [Fold, Stitch] or [Fold, Stitch, Trim] is
• selected in [Device Options] tab
• When [Booklet] is selected in [Device Options] tab
If you attempt to make a setting corresponding to the incongruous combinations described that cannot be set on
the printer driver, a message will be displayed. Check the details of the message and adjust the relationship with
other settings.
1.
Open [Device options] tab of the [Properties] window.
When displayed from an application with Windows 98.
•
For Windows NT4.0, the [Advanced] tab is displayed.
•
For Windows 2000/ XP, the [Device Settings] tab is displayed.
2.
Select [Stapling] from the [Printer features] field.
3.
Click the [▼] button beside the [Printer features] - [Change setting for]
box to display the list. Then select the number of staple to be used and
their position from the list.
[None] [Single(Portrait)] [Single(Landscape)] [SingleRight(Portrait)] [SingleRight(Landscape] [Double
Side(Portrait)] [Double Side(Landscape)] [Double SideRight(Portrait)] [Double SideRight(Landscape)]
[Double Top(Portrait)] [Double Top(Landscape)] can be selected.
The default is [None].
4.
Click the [OK] button to close the [Properties] window.
Adobe PS3
237
Chapter 5 Printing from Windows