Kyocera KM-8530 User Manual page 464

Reading In From HDD (Continued)
5.
In the [Scanner Box No. Set-up] window, enter the server name (IP
address) of the scanner you want to connect to, the scanner name for
the driver to identify the scanner, and the box number you entered
when scanning the document. Then click the [OK] button.
Once the Scanner setting has been set, this window is not displayed the next time you perform a
scanning task. To display this window and select another scanner, click the [Scanner Selection] but-
ton on the [Kyocera Mita Scanner Driver] window. Then click the [Add] button on the [Scanner Box No.
Set-up] window.
Limitation
Neither the DNS nor the NetBIOS names can be used as a Scanner Server name.
The [Kyocera Mita Scanner Driver] window will appear.
6.
Select a file from the file list shown in the [Kyocera Mita Scanner
Driver] window, then click the [Reading] button to allow the selected
file to be read in.
The selected file is read from the hard disk.
By default, the file is cleared from the controller's hard disk immediately after the file is fully read in. If you want, you
can override this default setting so that the file is held in the hard disk.
7.
You can open the read-in document within the application for editing/
saving.
Chapter 13 Loading in the Scanned Image Data
464