Chapter 7 Tandem Print; To Print With Two Copiers - Kyocera KM-8530 User Manual

Chapter 7 Tandem Print

To print with two copiers

PCL5e
Using two copiers (master copier and sub copier), prints can be made at the same time under the same printing
conditions. When printing a large number of copies, time required to complete the job can be shortened.
When either one of the two copiers is equipped with a print controller, tandem printing can be performed. When
both of the copiers are equipped with a print controller, the copier which receives the printing job instruction
functions as the master copier and the other one is the sub copier.
For the tandem printing, the two copiers should be connected by either method as follows.
• Connect the two copiers directly with a cross cable.
• Connect them with a straight cable via HUB.
Adobe PS3
In this case, the network functions cannot be used.
Use a cross cable or straight cable higher than the category type 5.
Tandem printing should only be set up by your authorized service representative.
Computer Master copier
Limitation
[Tandem Print] cannot be set in the following cases:
In case of Kyoceramita PCL5e:
• When [OHP-Interleave(Blank)] or [OHP-Interleave(Print)] is selected in [Paper] tab-[Media
Type]
• When [Collate] is not available in [Paper] tab-[Copies]
In case of Adobe PS3:
Windows:
• When [OHP-Interleave(Blank)] or [OHP-Interleave(Print)] is selected in [Paper] tab-[Paper
type]
• When [Group] is selected in [Device Options] tab-[Printer features]-[Collate]
Macintosh:
• When [OHP-Interleave(Blank)] or [OHP-Interleave(Print)] is selected in [Printer Specific
Options] dialog box(1)-[Media Type]
• When [Group] is selected in [Printer Specific Options] dialog box(2)-[Collate]
(p.336) Displaying the [Print] dialog box
Reference
Compliant
Sub copier
417
Chapter 7 Tandem Print
Chapter
7