Kyocera KM-8530 User Manual page 578

UNIX Printing through TCP/IP (Continued)
Setting Up a DEC ULTRIX 4.3 RISC or OSF1 Remote Printer
Use the following procedure to set up a remote printer on the host that sends jobs to the network inter-
face card.
1.
At the prompt, type: lprsetup, then select [add].
2.
Enter a name for your printer, then press [Enter].
3.
Do you want more information on specific printer types?
"
A list of ULTRIX-supported printers is listed.
4.
Type: remote, and press [Enter].
5.
Enter a printer synonym (alias) and press [Enter].
6.
Designate a spooler directory and press [Enter], or accept the default
spooler directory displayed and press [Enter].
7.
Designate a remote system name and press [Enter].
8.
Designate PORT1 as the remote system printer name and press
[Enter].
9.
You are asked to enter the name of a printcap symbol from a displayed
list. Type: Q, and press [Enter].
10.
Your configuration is displayed.
You are asked whether these values are final. Type: Y or N, and press Enter. An example is shown
below.
Printer #7 Symbol
lp (line printer)
rm (remote host)
rp (remote printer)
sd (spooler directory)
11.
Add comments to the printcap file. For example, you can type:
Lois' printer down the hall <Enter>
12.
Select exit to save your configuration, then press [Enter].
You are now prepared to print.
Type Representative Value
STR
STR Network Interface Card_host
STR PORT1
STR /usr/spool/lpd7
578
Chapter 24 UNIX Configuration
Press Enter.
"