Kyocera KM-8530 User Manual page 317

To adjust detailed settings of PostScript output format (Continued)
3.
Click the [▲] and [▼] buttons beside the [PostScript language level]
box to select either [2] or [3] for the language level used.
•
The default is [3].
•
Set [PostScript Options] - [PostScript Language Level] in Windows NT 4.0/2000/XP.
4.
Set each button and check box in the [Data format] field if you have to
change the data format.
• When you turning on the [ASCII data] button, data is sent in ASCII format.
• When you turning on the [Tagged binary communications protocol] button, all data except data of
special characters is sent in binary (8-bit) format via the parallel port.
• When you turning on the [Pure binary data] button, all data is sent in binary format.
• When you turning on the [Send CTRL+D before job] check box, the reset memory code
(CTRL+D) is sent before the print job. Turning on the [Pure binary data] radio button, you cannot
turn on this check box.
• When you turning on the [Send CTRL+D after job] check box, the reset memory code (CTRL+D)
is sent after the print job. Turning on the [Pure binary data] radio button, you cannot turn on this
check box.
•
The [ASCII data] button and the [Send CTRL+D after job] check box are turned on as default.
•
Windows NT 4.0/2000/XP does not support this function.
5.
Turn on the [Display alert for applications incompatible with driver fea-
tures] check box, if you want to alert for an application that is incom-
patible with driver features.
The setting in the [PostScript header] field is ignored if you have selected [Encapsulated PostScript
(EPS)] or [Archive format] in the [PostScript output format] box at step 2.
•
The default is [OFF].
•
Windows NT 4.0/2000/XP does not support this function.
6.
Click the [OK] button.
The [Advanced PostScript Options] dialog box disappears and the display returns to the [Properties]
window.
7.
Click the [OK] button to close the [Properties] window.
Chapter 5 Printing from Windows
317