Kyocera KM-8530 User Manual page 249

Chapter 5 Printing from Windows
To set Fold, Stitch, Trim (Trimmer Unit) (Continued)
●
Operating procedures of
PCL5e
Limitation
[Fold & Stitch] cannot be set in the following cases:
• When [DF-635 Finisher] is not available in [Setup] tab
• When [Tab sheet] or [OHP] is selected in [Paper] tab - [Media Type]
[Fold only] cannot be set in the following cases:
• When [Sub Tray] selected in [Paper] tab - [Output Tray]
• When [Collate] is not available in [Paper] tab
[Fold & Trim] cannot be set in the following cases:
• When [TU-108 Trimmer Unit] is not available in [Setup] tab
• When [Sub Tray] selected in [Paper] tab - [Output Tray]
• When [Collate] is not available in [Paper] tab
[Fold & Stitch] cannot be set in the following cases:
• When [Sub Tray] selected in [Paper] tab - [Output Tray]
• When [Collate] is not available in [Paper] tab
[Fold, Stitch & Trim] cannot be set in the following cases:
• When [TU-108 Trimmer Unit] is not available in [Setup] tab
• When [Sub Tray] selected in [Paper] tab - [Output Tray]
• When [Collate] is not available in [Paper] tab
[Z-Fold(A3, B4, 11 x 17, 8K)] cannot be set in the following cases:
• When [PZ-108 Punch Unit] selected in [Setup] tab
• When [Sub Tray] selected in [Paper] tab - [Output Tray]
[Z-Fold(8.5 x 14)] cannot be set in the following cases:
• When [PZ-108 Punch Unit] selected in [Setup] tab
• When [Sub Tray] selected in [Paper] tab - [Output Tray]
•
If you attempt to make a setting corresponding to the incongruous combinations described that cannot be set
on the printer driver, a message will be displayed. Check the details of the message and adjust the relationship
with other settings.
249