Initial Settings; Cpu Unit Settings - Omron CP1L Operation Manual

Initial Settings

Name Address
IOM Hold Bit A500.12
Forced Status Hold A500.13
BIt

CPU Unit Settings

Name Address
Status of DIP A395.12
Switch Pin 6
Manufacturing Lot A310 and
Number A311
DM Initial Value Settings
Name Address
DM Initial Values A345.04
Flag
DM Initial Values A751.11
Read Error Flag
DM Initial Values A751.12
Save Execution
Error Flag
DM Initial Values A751.13
Save Error Flag
DM Initial Values A751.14
Save Flag
DM Initial Values A751.15
Save Start Bit
DM Initial Values A752
Transfer Password
DM Initial Values A753.00
Save Area Specifi-
cations
Auxiliary Area Allocations by Function
Turn this bit ON to retain the status of the I/O Memory when shift-
ing from PROGRAM to RUN or MONITOR mode or vice versa or
when turning ON the power supply.
ON: I/O memory retained
OFF: I/O memory not retained
Turn this bit ON to preserve the status of bits that have been force-
set or force-reset when shifting from PROGRAM to MONITOR
mode or vice versa or when turning ON the power supply.
The status of pin 6 on the DIP switch on the front of the CPU Unit
is written to this flag every cycle.
The manufacturing lot number is stored in 5 digits hexadecimal. X,
Y, and Z in the lot number are converted to 10, 11, and 12,
respectively.
Examples:
Lot number 23805
A310 = 0823, A311 = 0005
Lot number 15X05
A310 =1015, A311 = 0005
ON when DM initial values are stored in the flash memory.
ON when an error occurred in transferring DM initial values from
the DM initial value area in flash memory to the DM Area.
ON when the DM Initial Values Transfer Password (A752) is
incorrect or when the DM Initial values area was not specified
when starting to transfer DM initial values from the DM Area to
the DM initial value area in flash memory.
ON when an error occurred in transferring DM initial values from
the DM Area to the DM initial value area in flash memory.
ON while DM initial values are being transferred from the DM
Area to the DM initial value area in flash memory.
OFF when the transfer has been completed.
Turn ON this bit to start transferring DM initial values. This bit is
valid only when a correct password is stored in A752 and the DM
Area Initial Value Area is specified (i.e., when A753.00 is ON).
The system will turn this bit OFF automatically when the transfer
has been completed.
Set the passwords here to transfer DM initial values between the
DM area and the DM initial value area in flash memory. The
transfer will not be started unless the correct password is set.
The transfer is started when A751.15 is turned ON.
The password will be cleared by the system when the transfer
has been completed.
A5A5 hex: Save initial values from DM to flash
Specifies the area to be transferred to flash memory.
Appendix C
Description
Description
Description
Access Updated
Read/write
Read/write
Access Updated
Read-only
Read-only
Access Updated
Read-only
Read-only
Read-only
Read-only
Read-only
Read/Write
Read/Write
Read/Write
597