Copying The System - Omron CP1L Operation Manual

Memory Cassette Functions
6-6-5 Procedures for Automatic Transfer from the Memory Cassette at
Startup

Copying the System

Type of protection
Protected by password. Over-
writing permitted and duplica-
tion prohibited.
Protected by password. Over-
writing and duplication both pro-
hibited.
• If a Memory Cassette is not mounted, data will be read from the flash
memory built into the CPU Unit to start operation regardless of the setting
of DIP switch pin SW2.
• CP1L CPU Units with 10, 14 or 20 I/O points. do not have D10000 to
D31999. These words will be treated as follows when data from a CPU
Unit with 10, 14 or 20 I/O points is transferred to a CPU Unit with 30, 40 or
60 I/O points or visa versa.
Transferring data from a CPU Unit with
10, 14 or 20 I/O points to one with 30,
40 or 60 I/O points
Transferring data from a CPU Unit with
30, 40 or 60 I/O points to one with 10,
14 or 20 I/O points
Use the following procedure to enable automatic transfer at startup.
1,2,3... 1. Prepare a Memory Cassette containing the required data.
When transferring the data to the Memory Cassette, set the operating
mode after automatic transfer at startup to PROGRAM mode (default).
2. With the power supply turned OFF to the CPU Unit, remove the cover from
the Memory Cassette slot and insert the Memory Cassette.
3. Open the cover for the CPU Unit's PERIPHERAL section and set DIP
switch pin SW2 to ON.
4. Turn ON the power supply to the CPU Unit.
5. The automatic transfer from the Memory Cassette will begin. The rest of
the procedure assumes that the operating mode after automatic transfer at
startup to PROGRAM mode (default).
6. After the automatic transfer has been completed, turn OFF the power sup-
ply to the CPU Unit.
7. Remove the Memory Cassette, and replace the Memory Cassette slot cov-
er.
8. Return the setting of DIP switch pin SW2 to OFF, and close the cover.
Transfer from CPU Unit
to Memory Cassette
No
No
"0000" will be written to D10000 to D31999
in the CPU Unit with 30, 40 or 60 I/O points.
D10000 to D31999 in the CPU Unit with 30,
40 or 60 I/O points will be ignored.
DIP switch pin
SW2 set to ON.
MEMORY
Section 6-6
Transfer from Memory
Cassette to CPU Unit
Yes
Transfer enabled only at
startup.
403