Omron CP1L Operation Manual page 10

Using the Unit Version
Labels
Functions Supported by Unit Version for CP-series CPU Units
Functions Supported by Unit Version 1.0 and 1.1
x
The following unit version labels are provided with the CPU Unit.
1.0
Ver.
1.0
Ver.
T h e s e L a b e l s c a n b e u s e d
t o ma n a g e d i f f e r e n c e s
i n t h e a v a i l a b l e
f u n c t i o n s a mo n g t h e U n i t s .
P l a c e t h e a p p r o p r i a t e l a b e l
o n t h e f r o n t o f t h e U n i t t o
s h o w w h a t U n i t
v e r s i o n i s a c tu a l l y b e i n g
u s e d .
These labels can be attached to the front of previous CPU Units to differenti-
ate between CPU Units of different unit versions.
Functionality is the same as that for CS/CJ-series CPU Units with unit version
3.0. The functionality added for CS/CJ-series CPU Unit unit version 4.0 is not
supported.
CP1H CPU Units
• CX-Programmer version 6.11 or higher is required to use CP1H-X@@@@-
@/XA@@@@-@ with unit version 1.1 or 1.0.
• CX-Programmer version 6.20 or higher is required to use CP1H-Y@@@@-
@ with unit version 1.1.
CPU Unit
Model
Unit version
Function
Pulse Allocated built-
outputs in I/O terminals
Special pulse
output terminals
Note 1. The unit version for the CP1H-X
2. The unit version for the CP1H-Y
3. CX-Programmer version 7.11 or higher is required to use CP1L CPU Units
with unit version 1.0.
4. CX-Programmer version 7.3 or higher is required to use CP1L CPU Units
with 10 I/O points.
Ver.
Ver.
CP1H CPU Unit
CP1H-@@@@-@
CP1H-XA@@@@-@
(See note 1.)
Ver. 1.1 or later Ver. 1.0
4 axes at 100 kHz 2 axes at 100 kHz
2 axes at 30 kHz
None
@@@@ @
- /XA
@@@@ @
- begins at 1.1.
CP1H-Y@@@@-
@
(See note 2.)
Ver. 1.1
2 axes at 100 kHz
2 axes at 1 MHz
@@@@ @
- begins at 1.0.