Installation And Removing - Omron CP1L Operation Manual

Installation and Removing

8-4 Installation and Removing
Installation
!Caution Always turn OFF the power supply to the CPU Unit and wait until all the oper-
Removing
The following processing explains how to install and remove a LCD Option Board.
ation indicators go out before installing or removing the LCD Option Board.
1,2,3... 1. Press the up/down lock levers on both sides of the Option Board slot cover
1 at the same time to unlock the cover, and then pull the cover out.
Check the alignment to make the corner cut of the LCD Option Board fit in
2.
the Option Board slot 1, and firmly press the LCD Option Board in until it
snaps into place.
Operation indicators
Switch DipSW4 of the CPU Unit to ON.
3.
Note DipSW4 is OFF at shipment
Press the up/down lock levers on both sides of the LCD Option Board at the
same time to unlock the Option Board, and then pull it out.
LCD Option Board
DipSW4
ESC ESC
Option Board slot 1
Corner Cut
ESC
OK
Back
Front
ESC
OK
Press
Lock lever
OK OK
Lock lever
Press
Section 8-4
493