Table of Contents
Advertisement
Switch Settings
2-2
Switch Settings
1, 2, 3...
18
Set the following switches on the BASIC Unit as described below. Details on
switch setting are provided in Section 1 Introduction.
1. Set a Unit number in the range of 0 to 15. Do not set
the same Unit Number as those of the other CPU
Bus Units.
2. Set the RUN/STOP switch to the STOP position.
3. Open the battery compartment and set all the
switch pins of the DIP switch to the OFF position to
get the following settings:
Pin no.
DIP switch setting
1
Memory write-protected (OFF)
2
Memory switches disabled (OFF)
3
Not used (OFF)
4
Termination resistance (OFF)
Section 2-2
Advertisement
Chapters
Table of Contents
