Installing And Removing Memory Cards; Memory Cards; Pc Card Slots; Installing A Memory Card - Omron SYSMAC C200HW-PCU01 Operation Manual

Installing and Removing Memory Cards

4-6

Installing and Removing Memory Cards

4-6-1 Memory Cards

4-6-2 PC Card Slots

4-6-3 Installing a Memory Card

1, 2, 3...
40
This section includes information on the memory cards to be used and explains
how to install memory cards in the PC card slots in the front surface of the PC
Card Unit.
Use memory cards that fall within the following range of current consumption:
(1 slot) ≤ 0.5 A, I
I
5V
I (2 slots) + 3.4 x I
5V
Before purchasing memory cards (SRAM, FLASH, or ATA), always make sure
that they can be used with Phoenix PCM Plus 3.2.
Slot 1: A type-I, -II, or -III PC card can be mounted in this slot.
Slot 2: A type-I or -II PC Card can be mounted in this slot. If, however, a type-III
PC Card is mounted in slot 1, slot 2 cannot be used.
Note Always use the same type of card in each slot. If a different type of card is
mounted in the same slot, an error will occasionally occur depending on the
types of the cards.
1. Mount a memory card in a PC card slot as shown below. Press the memory
card until it is aligned with the eject buttons.
Eject buttons
2. If another memory card is to be installed, repeat Step 1.
(1 slot) ≤ 0.1 A
12V
(2 slots) ≤ 1.0 A
12V
Slot 2
Section 4-6
Slot 1
Back
Facing
side
Before inserting the card, make
sure that it is oriented correctly.