Mapping Dscp Values To Queues - NETGEAR ProSafe GS700TP Software User Manual

GS700TP Smart Switch Software User Manual
1. Click QoS > Mapping > CoS to Queue. The CoS to Queue Page opens:
Figure 5-62
The CoS to Queue Page contains the following fields:
– Class of Service – Specifies the CoS values, where 0 is the lowest and 7 is the highest.
– Queue – Defines the traffic forwarding queue to which the CoS is mapped. Four traffic priority
queues are supported. The lowest priority is 1 and is the highest is 4.
– Restore Defaults – Restores the device factory defaults for mapping CoS values to a forwarding
queue.
2. Define the relevant fields.
3. Click . The CoS value is mapped to a queue and the device is updated.

Mapping DSCP Values to Queues

The DSCP to Queue Page contains fields for mapping DSCP settings to traffic queues. For example, a
packet with a DSCP tag value of 2 can be assigned to queue 2. The following DSCP values are reserved and
cannot be modified by the system: 3, 11, 19 ,27, 35, 43, 51, 59.
To map CoS values to queues:
114 Configuring The Device Using Your Browser
v1.0, January 2007