NETGEAR ProSafe GS700TP Software User Manual page 107

GS700TP Smart Switch Software User Manual
1. Click Address Table > Dynamic Addresses. The Dynamic Addresses Page opens:
Figure 5-53
The Dynamic Addresses Page contains the following fields:
– Address Aging – Specifies the amount of time the MAC address remains in the Dynamic MAC
Address table before it is timed out if no traffic from the source is detected. The default value is 300
seconds.
– Clear Table – Removes the current values from the table.
– Interface – Specifies the interface for which the table is queried. There are two interface types
from which to select.
– Port – Indicates the Port for which the table is currently queried
– LAG – Indicates the LAG for which the table is currently queried
– MAC Address – Specifies the MAC address for which the table is queried.
– VLAN ID – Specifies the VLAN ID for which the table is queried.
– Address Table Sort Key – Specifies the means by which the Dynamic MAC Address Table is
sorted. The address table can be sorted by address, VLAN, or interface.
– Address– indicates that the table is sorted by MAC address.
98 Configuring The Device Using Your Browser
v1.0, January 2007