Defining Server Logs - NETGEAR ProSafe GS700TP Software User Manual
Smart switch
Hide thumbs
Also See for ProSafe GS700TP:
- Software administration manual (251 pages) ,
- Installation manual (41 pages) ,
- Hardware installation manual (36 pages)
Table of Contents
Advertisement
GS700TP Smart Switch Software User Manual
2. Click
Defining Server Logs
The Server Logs Page contains information for viewing and configuring the remote log servers. New log
servers can be defined and the log severity sent to each server.
To open the Server Logs Page:
1. Click Logs > Server Logs. The Server Logs Page opens:
Figure 5-29
The Server Logs Page contains the following fields:
–
ID – Displays the table entry number.
–
Server – Specifies the server's IP address to which logs can be sent.
–
UDP Port – Defines the UDP port to which the server logs are sent. The possible range is 1 -
65535. The default value is 514.
66
. The Flash Logs are cleared.
v1.0, January 2007
Configuring The Device Using Your Browser
Advertisement
Table of Contents
