NETGEAR ProSafe GS700TP Software User Manual page 80

– Suspended – The port is in standby, and is currently not receiving or transmitting traffic.
– Active – The port is active and is currently receiving and transmitting traffic.
– Disable – The port is disabled, and is not currently receiving or transmitting traffic.
– Admin Speed – Displays the configured rate for the port. The port speed determines what speed
setting options are available. Port speed can only be configured when auto negotiation is disabled.
The possible field values are:
– 10M – Indicates the port is currently operating at 10 Mbps.
– 100M – Indicates the port is currently operating at 100 Mbps.
– 1000M – Indicates the port is currently operating at 1000 Mbps.
– Current Port Speed – Indicates the current port speed.
– Admin Duplex – Displays the port duplex mode. This field is configurable only when auto
negotiation is disabled, and the port speed is set to 10M or 100M. This field cannot be configured
on LAGs. The possible field values are:
– Full – The interface supports transmission between the device and its link partner in both
directions simultaneously.
– Half – The interface supports transmission between the device and the client in only one
direction at a time.
– Current Duplex Mode – Indicates the current duplex mode.
– Auto Negotiation – Displays the auto negotiation status on the port. Auto negotiation is a protocol
between two link partners that enables a port to advertise its transmission rate, duplex mode, and
flow control abilities to its partner. The possible field values are:
– Enable – Enables auto negotiation.
– Disable – Disables auto negotiation.
– Current Auto Negotiation – Indicates the current auto negotiation status on the port.
– Admin Advertisement – Defines the auto negotiation setting the port advertises. The possible field
values are:
– Max Capability – Indicates that all port speeds and duplex mode settings are accepted.
– 10 Half – Indicates that the port advertises for a 10 Mbps speed port and half duplex mode
setting.
– 10 Full – Indicates that the port advertises for a 10 Mbps speed port and full duplex mode
setting.
– 100 Half – Indicates that the port advertises for a 100 Mbps speed port and half duplex mode
setting.
– 100 Full – Indicates that the port advertises for a 100 Mbps speed port and full duplex mode
setting.
Configuring The Device Using Your Browser
GS700TP Smart Switch Software User Manual
v1.0, January 2007
71