NETGEAR ProSafe GS700TP Software User Manual page 160

1. Click Monitor > Cable Test. The Cable Test Page opens:
Figure 5-91
The Cable Test Page contains the following fields:
– Interface – Specifies the port to which the cable is connected.
– Test Result – Displays the cable test results by clicking the button. The possible values are:
– No Cable – Indicates that a cable is not connected to the port.
– Open Cable – Indicates that a cable is connected on only one side.
– Failed – Indicates that a short has occurred in the cable.
– OK – Indicates that the cable passed the test.
– Cable Fault Distance – Indicates the distance from the port where the cable error occurred.
– Last Update – Indicates the last time the port was tested.
– Test – When clicked, performs cable test.
– Cable Length – Indicates the approximate cable length. This test can only be performed when the
port is up and operating at 1 Gbps.
Configuring The Device Using Your Browser
GS700TP Smart Switch Software User Manual
v1.0, January 2007
151