Spanning Tree - NETGEAR ProSafe GS700TP Software User Manual

– VLAN – Indicates the ID of the current VLAN.
– Interface – Indicates that the table is sorted by the interface.
– Back – Displays the previous page of the configuration information, if there is a previous page.
– Next – Displays the following page of the configuration information, if there is a page following
the current page.
2. Define the relevant fields.
3. Click . The Dynamic Address Aging field is defined and the device is updated.
To query the Dynamic MAC Address Table:
1. Click Address Table > Dynamic Addresses. The Dynamic Addresses Page opens.
2. Define the relevant fields.
3. Click . The Dynamic MAC Address Table is queried and the results are displayed.
Configuring the Spanning Tree Protocol
Spanning Tree Protocol (STP) provides tree topography for any arrangement of bridges. STP also provides a
single path between end stations on a network, eliminating loops. Loops occur when alternate routes exist
between hosts. Loops in an extended network can cause bridges to forward traffic indefinitely, resulting in
increased traffic and reducing network efficiency.
This section contains the following topics:
• Configuring the Spanning Tree Protocol
• Defining STP on Interfaces
Configuring the Spanning Tree Protocol
To configure STP on the device:
Configuring The Device Using Your Browser
GS700TP Smart Switch Software User Manual
v1.0, January 2007
99