Mapping Cos Values To Queues - NETGEAR ProSafe GS700TP Software User Manual

– Enable Egress Shaping Rate– Indicates if Egress Shaping is enabled on the interface. The
possible field values are:
– Checked – Enables Egress Shaping limiting on the interface.
– Unchecked – Disables Egress Shaping limiting on the interface.
– Committed Burst Size (CbS) – Defines CbS values. The field range is is 128Kbps -16Mbps.
– Enable Ingress Shaping Rate – Indicates if Ingress Shaping Rate is enabled on the interface. The
possible field values are:
– Checked – Enables Ingress Shaping limiting on the interface.
– Unchecked – Disables Ingress Shaping limiting on the interface.
– Rate Limit – Defines the amount of bandwidth assigned to the interface.
3. Define the relevant fields.
4. Click . The bandwidth settings are saved to interface and the device is updated.

Mapping CoS Values to Queues

The CoS to Queue Page contains fields for mapping CoS values to traffic queues. Range: 1-4.
To map CoS values to queues:
Configuring The Device Using Your Browser
GS700TP Smart Switch Software User Manual
v1.0, January 2007
113