NETGEAR ProSafe GS700TP Software User Manual page 118

– Default CoS – Determines the default CoS value for incoming packets for which a VLAN tag is
not defined.
– Restore Defaults – Restores the factory CoS default settings to the selected port.
– Checked – Restores the factory CoS default settings to the ports.
– Unchecked– Maintains the current CoS settings.
2. Define the relevant fields.
3. Click . Quality of Service is enabled on the device.
To modify QoS:
1. Click QoS > General > CoS. The CoS Page opens.
2. Click an interface. The Modify Port Priority Page opens:
Figure 5-58
In addition to the CoS Page, the Modify CoS Page has the following field:
– Set Default User Priority – Sets the default user priority. The possible field values are 0-7. The
default CoS value is 0. With the default settings, 0 is the lowest and 7 is the highest priority.
3. Modify the relevant fields.
Configuring The Device Using Your Browser
GS700TP Smart Switch Software User Manual
v1.0, January 2007
109