Siemens SINAMICS PERFECT HARMONY GH180 Function Manual page 376

Software user interface
9.2 Multi-Language Keypad
Fault LED Conditions
The fault LED can be flashing, on continuously, or off.
• A flashing fault LED means that an alarm is either active or unacknowledged.
• A fault LED that is on continuously means that a fault condition exists.
LED conditions are detailed in the following table:
Table 9-8 Fault LED Status: Multi-language Keypad
Fault LED Condition Display
1
Flashing Status display will be reduced in height and
alarm name will be shown in yellow box at
bottom of display.
Flashing* Status display will be reduced in height and
alarm name will be shown in yellow box at
bottom of display.
Flashing none
Flashing Status display will be reduced in height and
(see figure below) alarm names will be shown in rotation in yel‐
low box at bottom of display.
On continuously*** Fault name
Note: Background is red for fault display.
On continuously*** Fault name within display**
Note: Background is red for fault display.
1
*
**
*** Assumes "Fault display override" (ID 8200) is "Off".
374
Up to three faults can be displayed simultaneously on the display.
After an alarm condition is cleared, the fault LED will continue to flash until the alarm is
acknowledged. Alarms are self-clearing.
Press the [FAULT RESET] key to acknowledge the alarm.
Use the down and up arrow keys to cycle through the active fault list.
Fault Con‐ Alarm Condition
dition
N/A Active (not ac‐
knowledged)
N/A Cleared (not ac‐
knowledged)
N/A Active (acknowl‐
edged)
N/A Multiple unac‐
knowledged alarms
Active N/A
Multiple N/A
faults
Operating Manual, A5E50491925A
Alarm Acknowl‐
edged or Fault
Reset?
No
No
Yes
No
No
No
NXGPro+ Control Manual