Siemens SINAMICS PERFECT HARMONY GH180 Function Manual page 359

Figure 9-9
Modifying Parameter Values
The following sections illustrate the steps to take if attempting to locate and change the
following parameters:
• Ratio Control
• Motor Frequency
Example for changing ratio control parameters:
The metering display shows the commanded speed reference in percent.
Figure 9-10
1. Press the following key combination: [SHIFT] + [2].
Figure 9-11
2. From this point, you can select from the nine standard menus.
Use the up [⇑] and down [⇓] arrow keys, to select the desired menu.
NXGPro+ Control Manual
Operating Manual, A5E50491925A
Dynamic Programmable Meter Display in Regeneration Mode
Status display in metering mode
D r i v e
( A r r o w K e y s S e l e c t )
Status display after [SHIFT] + [2] key sequence
( 2 )
Software user interface
9.1 SIMATIC Keypad
357