Siemens SINAMICS PERFECT HARMONY GH180 Function Manual page 171

Parameter ID
Parameter da‐ 9160
ta
Note: Not
available in
NXGPro+
Parameter 9170
dump
Menu based 9111
timer setup
MenuTimer 9112 to
1-8 9119
MenuTimer 9121 to
9-16 9128
Use parameter upload functions to transmit data from the drive to a USB connected disk drive.*
Use parameter download functions to move data from a USB connected disk drive to the drive.*
NOTICE
* NXGPro+ uses a standard driver and does not allow the installation of drivers, therefore some
USB disk devices may not be compatible with NXGPro+.
• When attempting to upload information using a USB disk drive, check the keypad display for
• If the upload fails, change the brand or type of USB flash disk and retry.
• Refer to "USB flash disk requirements", "Known Issues with USB flash disks", and "Keypad
Table 6-101 TCP/IP Setup Menu (9300) Parameters
Parameter ID Unit
IP address 9310
Subnet 9320
mask
Gateway ad‐ 9330
dress
NXGPro+ Control Manual
Operating Manual, A5E50491925A
Unit Default Min
Function
Function
Submenu
Sec 0.0 0.0
Sec 0.0 0.0
a failure message such as, "An error has occurred" or "Error opening output file".
error messages" for more information on USB.
Default Min
172.17.20.16 0.0.0.0 255.255.255.255
255.255.0.0 0.0.0.0 255.255.255.255
172.17.1.1 0.0.0.0 255.255.255.255
6.18 Options for Communications Menu (9)
Max Description
Transfer the current configuration file to a remote sys‐
tem.*
Obtain a print out of the current configuration data.*
Access the menu-based SOP timers 1 to 16.
86400.0 Menu timers 1 to 8 timeout.
86400.0 Menu timers 9 to 16 timeout.
Max Description
Enter the drive IP address in dotted decimal.
Enter the drive subnet mask in dotted deci‐
mal (keypad only).
Enter the drive gateway address in dotted
decimal (keypad only).
Parameter Assignment/Addressing
169