Siemens SINAMICS PERFECT HARMONY GH180 Function Manual page 170

Parameter Assignment/Addressing
6.18 Options for Communications Menu (9)
Parameter ID
Display Network 9950
Monitor
Serial echo back test 9180
Note: Modems are
not supported on
newer drives fitted
with NXGPro+ Con‐
trols or on older
drives updated with
NXGPro+ controls.
SOP Functions 9110
TCP/IP setup 9300
* Refer to Section Network Fast Register Access for PLC Applications in Chapter Advanced
Operating Functions for additional information.
Table 6-99 Serial Port Setup Menu (9010) Parameters
Parameter ID
Modem pass‐ Modems are not supported on newer drives fitted with NXGPro+ Controls or on older drives updated with
word NXGPro+ controls.
Table 6-100 SOP and Serial Functions Menu (9110) Parameters
Parameter ID
System pro‐ 9120
gram down‐
load
Note: Not
available in
NXGPro+
System pro‐ 9130
gram upload
Display sys 9140
prog name
Select system 9146
program
Display drctry 9147
version
Multiple con‐ 9185
fig files
Parameter da‐ 9150
ta upload
168
Unit Default Min
Function
Function
Submenu
Submenu
Unit Default Min
Unit Default Min
Function
Function
Function
nowago.hex
Function
Off
Function
Max Description
Refer to the NXGPro+ Communications Manual.
Access functions that utilize the local serial port.
See Table Serial Functions Menu (9110).
Access functions that set the parameters for TCP/IP.
See Table TCP/IP Setup Menu (9300).
Max Description
Max Description
Transfer the SOP to a USB connected disk drive.*
Transfer the SOP to a USB connected disk drive.*
Display the current SOP name.
Display the list of SOP files on the flash disk to select the
active one.
Display the current directory file version.
Enable multiple configuration files.
Transfer the current configuration file from a remote
system.*
NXGPro+ Control Manual
Operating Manual, A5E50491925A