Siemens SINAMICS PERFECT HARMONY GH180 Function Manual page 104

Parameter Assignment/Addressing
6.5 Options for Drive Menu (2) - first part
Parameter ID
Rated output 2040
current
Hall Effects 2041
Voltage
Rated Leading Vars 2042
Rated Lagging Vars 2043
Control loop type 2050
Parallel system 2051
Drives/motor wind‐ 2052
ing
Number of windings 2053
Drive index 2054
Service Mode 2056
PMM Control 2980
* Rated input current calculation is derived as follows:
Rated Input Current =
1 Changing the control loop algorithm type to OLTM or V/Hz disables fast bypass (2600) and
spinning load (2430) regardless of parameter setting.
102
Unit Default Min
A 100.0 12.0
V 24
% 50.0 0.0
% 50.0 0.0
OLVC
Disable
1 1
1 1
0 0
0 0
[(kVA rating) x (802)] ÷ [(√3) x (rated nominal primary voltage)
x (0.96) x (0.94)
= [(kVA rating) ÷ (rated nominal primary voltage)] x 513.11
Max Description
1500.0 Rated drive output current RMS. Set equal to the cell
output current rating.
Note: Size the output Hall effects and burden resis‐
tors for the cell current rating.
The required voltage of the drive's hall effect trans‐
ducers. Possible options are:
• 15 V
• 24 V
75.0 Rated leading VAR output in percent of rated input
transformer VA.
75.0 Rated lagging VAR output in percent of rated input
transformer VA.
Select control loop algorithm type
• V/Hz for parallel motors.
• OLVC for single induction motors.
• CLVC for single induction motors with speed sen‐
sor(s).
• OLTM for checking cell modulation and testing
Hall effect transducer only. Not intended for con‐
tinuous motor or load control.
• SMC without speed sensor.
• CSMC with speed sensor.
• SMDC which automatically sets high starting tor‐
que.
• PMM.
Enable parallel drive control operation.
99 Number of drives connected to a single motor.
99 Number of sets of motor windings.
255 Drive sequence number determined by PLC.
99999 Service mode register.
Menu for PMM control.
:
1
NXGPro+ Control Manual
Operating Manual, A5E50491925A