Yamaha YZF1000RJ Service Manual page 82

•
•
•
•
•
•
•
I
IANDSJP
1 • ~ I
THROTTLE CABLE ADJUSTMENT .
~
---------------------------
3- 23
4. Adjust:
• Throttle cable free play
**********************************
Adjustment steps:
NOTE: - - - - - - - - - - - - - -
When the motorcycle is accelerating, throt·
tie cable #1 (Dis pulled and throttle cable #2
®
is pushed.
1st step:
• Loosen the locknut@ on throttle cable #2 .
•Turn the adjuster@ in or out to take up
any slack on throttle cable #2.
2nd step:
•Loosen the locknut® on throttle cable #1.
• Turn the adjuster @ in or out until the
specified free play is obtained.
Turning in: Free play is increased.
Turning out: Free play is decreased.
• Tighten the locknuts .
NOTE: - - - - - - - - - - - - - -
If the specified free play cannot be obtained
on the carburetor end of the cable, use the
adjuster on the handlebar end.
Additional step:
• Pull back the rubber covers on · the
adjuster.
• Loosen the locknut
(J).
•Turn the adjuster @ in or out until the
specified free play is obtained.
Turning in: Free play is increased.
Turning out: Free play is decreased.
• Tighten the locknut.
A
WARNING
After adjusting, turn the handlebars to the
right and to the left to ensure that this
does not cause the engine idling speed to
change.
**********************************