Yamaha YZF1000RJ Service Manual page 203

•
•
•
•
•
•
•
ENGINE ASSEMBLY AND ADJUSTMENT
I
ENG
I \mil
4- 69
· . Universal clutch holder:
YM-91042/90890-04086
3.Bend:
• Lock washer tab
NOTE: - - - - - - - - - - - -
Bend the lock washer tab along a flat side
of the nut.
4.lnstall:
• Push rod #2 G)
•Ball®
• Push rod #1 @
(with the 0-ring @)
•Bearing@
• Washer@
NOTE: - - - - - - - - - - - -
• First, insert the rounded end @ of push
rod #2 into the clutch boss.
• Apply lithium soap base grease onto push
rod #1, #2 and onto the ball.
5.lnstall:
• Friction plates
• Clutch plates
NOTE: - - - - - - - - - - - -
• Start with a friction plate and alternate
between a clutch plate and a friction plate.
• Be sure to align the mark@ on the clutch
housing with the notch (6) on friction plate
G).
6.lnstall:
• Pressure plate G)
NOTE: - - - - - - - - - - - -
Align the punched mark @ on the. clutch
boss with the punched mark@on the pres-
sure plate .
7.lnstall:
• Clutch springs
• Bolts (clutch springs)
'\-.. ,,._ Bolt (clutch spring):
~~
8 Nm (0.8 m • kg, 5.8 ft • lb)
NOTE: - - - - - - - - - - - -
Tighten the clutch spring bolts in stages,
using a crisscross pattern.