Yamaha YZF1000RJ Service Manual page 192

•
ENGINE ASSEMBL
v
AND ADJUSTMENT
I
ENG
I '-I
•
.
4-
58
4.lnstall:
• HY-VO chain G)
• Timing chain ®
(onto the crankshaft)
• Crankshaft assembly @
• HY-VO chain drive gear@
• Starter clutch assembly®
NOTE:
Pass the timing chain through the timing
chain cavity. Fasten a wire to the timing
chain to retrieve it in case it falls into the
crankcase .
5.lnstall:
• Shaft (starter clutch) G)
•Bearing®
• Bearing retainer@
~
- Bolt (bearing retainer):
~~
10 Nm (1.0 m • kg, 7.2 ft• lb)
6.lnstall:
• Starter idle gear G)
•Shaft®
7.lnstall:
• Oil spray nozzle G)
• Gasket
• Oil plug plate ®
NOTE: - - - - - - - - - - - - -
When installing the oil spray nozzles, align
the pin @ with the slot@ in the crankcase.
~
- Bolt (oil plug plate):
~~
10 Nm (1.0 m • kg, 7.2 ft• lb)
8.lnstall:
• Oil delivery pipe #5 G)
(with O-rings)
NOTE: - - - - - - - - - - - -
Lubricate the O-rings with lithium soap
base grease.
Bolt (oil delivery pipe):
10 Nm (1.0 m • kg, 7.2 ft• lb)
•
•
•
•
•
•
•