Table of Contents
Advertisement
•
•
•
•
•
•
•
_ _ _ _ _ _ _ _ _ _ _ _ FR_O_N_T_F_OR_K_ICHASI~1
7 - 47
1.lnsta II:
• Damper rod G)
Allow the damper rod to slide slowly down
the inner tube
®
until it protrudes from the
bottom, being careful not to damage the
inner tube.
A
WARNING
Always use new copper washers .
2.Lubricate:
• Inner tube (outer surface)
Recommended lubricant:
__,.
Fork oil 01 or equivalent
3.lnstall:
• Piston metal G)
4.Tighten:
• Bolt (damper rod)
Bolt (damper rod):
35 Nm (3.5 m • kg, 25
ft •
lb)
LOCTITE®
NOTE: - - - - - - - - - - - -
Fully insert the damper rod holder until one
of the ends @ contacts the compression
damping force adjusting screw <Ii).
If the damper rod holder end and compres-
sion damping force adjusting screw are not
correctly aligned, the damper rod holding
bolt cannot be tightened.
5.lnstall:
• Slide metal G)
Use a fork seal driver.
Fork seal driver:
YM-01442/90890-01442
Advertisement
Table of Contents
Troubleshooting
