Yamaha YZF1000RJ Service Manual page 220

ENGINE ASSEMBLY AND ADJUSTMENT
I
ENG
I '\al
14.lnstall:
• 0-rings
• Carburetor joints (D
(with the vacuum hose)
• 0-rings
• Water jacket joint (outlet) ®
(with the thermostatic valve housing and
carburetor heater hoses)
• Radiator hose (inlet) @
NOTE:
Install the carburetor joints with the "L"
mark onto the #1 and #2 cylinders and the
carburetor joints with the "R" mark onto
the #3 and #4 cylinders.
4- 86
~
Bolt (carburetor joint):
~
10 Nm (1.0 m • kg, 7.2 ft• lb)
15.Connect:
• Coolant reservoir hose
©
16.lnstall:
• Drive sprocket (D
(with the drive chain)®
• Lock washer@
• Nut (drive sprocket)
©
Nut (drive sprocket):
80 Nm (8.0 m • kg, 58 ft • lb)
A
WARNING
Always use a new lock washer.
NOTE: - - - - - - - - - - - -
While applying the rear brake, tighten the
drive sprocket nut.
17.Bend:
• Lock washer tab
(along a flat side of the nut)
18.lnstall:
• Gasket
• Dowel pins
• Drive sprocket cover
CD
Bolt (drive sprocket cover):
10 Nm (1.0 m • kg, 7.2 ft• lb)
LOCTITE®
•
•
•
•
•
•