Yamaha YZF1000RJ Service Manual page 380

_ _ _ _ _ _ _ _ _ _ _ co_o_L_tN_G_s_vsTEM
I
ELEC
ID I
EB807010
TROUBLESHOOTING
IF THE FAN MOTOR FAILS TO TURN:
IF THE WATER TEMPERATURE METER FAILS TO MOVE WHEN THE ENGINE IS WARM:
Procedure
Check:
1.Fuses (main, ignition, signal and fan)
2.Battery
3.Main switch
4.Fan motor
NOTE: - - - - - - - - - - - -
• Remove the following part(s) before trou-
bleshooting:
1)Seats
2)Side panel (left)
3)8ottom cowling (front)
4)Bottom cowling
5)Side cowlings (left and right)
• Use the following special tool(s) for trou-
bleshooting.
EB802011
1.Fuses (main, ignition, signal and fan)
• Remove the fuses.
• Connect the pocket tester
(Q
x 1) to the
fuses.
• Check the fuses for continuity.
~
CONTINUITY
EB802012
2.Battery
• Check the battery condition.
Refer to "BATTERY INSPECTION"
CHAPTER 3.
Open-circuit voltage:
12.8 V or more at 20
·c
(68°F)
~
CORRECT
*
in
5.Thermo switch
6.Thermo unit
7.Water temperature
a.Wiring connections (the entire cooling system)
Pocket tester:
VU-03112/90890-03112
NO CONTINUITY
+
I
Replace the f_us_e_<_s>_. _________
I
INCORRECT
+
• Clean the battery terminals.
• Recharge or replace the battery.
8- 50
•
•
•
•
•
•
•