Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Programming Guide
[CO/Qsig-Master(PRI only)/Qsig-Slave(PRI only)] T306
30 s (BRI), 0 s (PRI23)
0-255 s
Reserved for future use.
None
[CO/Qsig-Master(PRI only)/Qsig-Slave(PRI only)] T310
0 s (BRI), 30 s (PRI23)
10-300 s
Specifies the maximum time that the system waits after receiving
the Incoming Call Proceeding (call setting acceptance) message,
before receiving the continuance message.
None
[CO/Qsig-Master(PRI only)/Qsig-Slave(PRI only)] T3D3
10 s (BRI), 30 s (PRI23)
1-120 s
Specifies the time that the system tries to establish L2 in
"Permanent mode."
None
[CO/Qsig-Master(PRI only)/Qsig-Slave(PRI only)] T3D9
20 s
0-255 s
Specifies the time that the system tries to disconnect L2 in "Call-
by-Call mode."
None
[Extension] T200
1 s
1-5 s
Specifies the maximum time that the system waits after sending the
L2 command to ISDN, before receiving the reply to it.
None
Configuration
41