Table of Contents
Advertisement
Line
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
208
Answer Wait Timer
None
1.
None
2.
1 min
3.
2 min
4.
3 min
5.
4 min
Specifies the length of time in minutes the system waits, after an
outgoing CO call is made, before the other party answers the call.
If the call is not answered before this timer expires, the call will be
disconnected automatically.
(Assignable only when T1 [TIE/DID]/BRI/PRI23 card is installed
in the system.)
None
[CPC Signal] OUT Detection
Enable: DID card, Disable: ELCOT/GCOT/LCOT/T1 [GCO]/T1
[LCO] card
1.
Enable
2.
Disable
Specifies whether CPC Detection on outgoing CO calls is enabled
or disabled.
If enabled, the system disconnects the line with the time set in
program "[CPC Signal] OUT Detection—Detection Time" when
the CPC signal is detected.
• 1.3 System Features (F/G)
— Calling Party Control (CPC) Signal Detection
[CPC Signal] OUT Detection—Detection Time
400 ms
1.
None
2.
6.5 ms
3.
(2-75)
8 ms
Specifies the expected minimum duration for detecting CPC
(Calling Party Control) signal on outgoing CO calls.
(Assignable for ELCOT, GCOT, LCOT, T1 [GCO] and T1 [LCO]
cards.)
• 1.3 System Features (F/G)
– Calling Party Control (CPC) Signal Detection
Programming Guide
Advertisement
Table of Contents
