Panasonic LX-TD500 Programming Manual page 20

Configuration
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
20
Pulse Feedback Tone
Yes
1.
Yes
2.
No
On outgoing CO calls, the dialed number is toned out, which
informs the extension user that dialed number has been dialed out.
The dialed number is toned out by default. Select "No" to turn off
the pulse feedback tone.
None
Caller ID
—
—
You can enter into "Caller ID" screen (Section "1.2.6 Card
Properties (ELCOT) – Caller ID") by clicking
screen.
None
Inter-digit Pause
830 ms
1.
630 ms
2.
830 ms
3.
1030 ms
Used to distinguish between each pulse signal. To meet the
requirements of your Central Office, select the appropriate value
that represents the delay between dial pulses.
(This setting is only required when using dial pulse trunks.)
None
Pulse Break Time Adjustment
0 ms
-16 to +16 ms in 4 ms increments
Specifies the pulse break time for pulse digits.
None
Caller ID
on this
Programming Guide