Panasonic LX-TD500 Programming Manual page 205

Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Programming Guide
Destination—Day/Night/Lunch/Break
Day, Night: 1001, Lunch, Break: Blank
3-4 digits consisting of 0-9
Specifies the destination for the trunk line whose "Incoming Type"
is set to "DIL."
The following numbers can be assigned as the destination:
Extension numbers, FDNs.
(Assignable only when "DIL" is specified in "Incoming Type"
programming.)
Note
• When "Incoming Type" of the ISDN trunk line is set to "DID
(ISDN)," you can specify the destination DN/FDN as
"Destination." In this case, the destination DN/FDN
specified by this setting is available, not that specified in "9-
1 DID Dial Registration" screen.
• 1.5 Attended Features (F/G)
– Direct In Lines (DIL)
• 2.3 ISDN Attended Features (F/G)
– Direct Inward Dialing (DID)
Subscriber
Blank
Up to 16 digits consisting of 0-9,
Specifies the number which is used as the CLIP (Calling Line
Identification Presentation) number.
Notes
• When an extension user makes an outside call using an ISDN
BRI line, the number stored in "DN" <Section "1.2.9 Card
Properties (BRI) – SPID/DN" in the Programming Guide> is
displayed on the telephone of the other party as the CLIP
number.
• Specify the registered Central Office calling number for
correct operation of CLIP.
• 2.2 ISDN Originating Features (F/G)
– Calling Line Identification Presentation (CLIP)
• 4.3.19 Calling Line Identification Presentation (CLIP) (U/M)
or #
Line
205