Panasonic LX-TD500 Programming Manual page 312

Maintenance
Parameter
Default
Value Range
Description/Function
Reference
312
Automatic Initialization Command
AT&F0Q0E0V1S0=1X0&D0
Up to 80 characters consisting of 0-9, A-Z, a-z or the following
marks: ! # $ % ( ) + , - / : ; < = > ? @ &.
Specifies Modem Automatic Initialization Command.
Note
• A hardware flow control cannot be done by the
communication port of KX-TD500. Therefore, the hardware
flow control of your modem must be disabled to
communicate correctly. It depends on the type of the modem
you use. In most cases, hardware flow control can be
disabled by sending the "&K0" command from the PBX to
the external modem. (Please refer to the manual of the
external modem you use for further information.) It is
recommended to add this command to "Automatic
Initialization Command," the command to initialize the
modem automatically every time an external modem is
plugged into the RS-232C Port 1.
• 1.3 System Features (F/G)
– External Modem Control
• 4.3.36 External Modem Control (U/M)
Programming Guide